Hello, in previous posts plc247.com has guided you to use some types of PLC and HMI used to control Hitachi NES1 Inverter via Modbus-RTU, today I will continue to guide you to use HMI Weintek to control it simply and easily.
The HMI model Weintek plc247.com uses is MT8071iE , both Weintek MT8071iE and Hitachi NE-S1 have a built-in RS485 port so we can connect them together via “Modbus RTU”.
Weintek MT8071iE & Hitachi NE S1 “Wiring Diagram”
Note: If the communication distance is long, use an additional “120-Ohm Terminal Resistor”
Hitachi NE-S1 Modbus RTU Configuration
Below is a table of communication parameters that need to be set up for the “Hitachi NE S1 Inverter” so that it can be controlled by Modbus-RTU Communication
+ Hitachi NE S1 “Modbus RTU” Parameters Setting
+ Hardware SW5 Selection
Registers Address Table
HMI Weintek Modbus Configuration
In order for the Weintek HMI to connect to the Hitachi NES1 controller, we need to set the communication parameters of the HMI exactly the same as the VFD
HMI Weintek “Modbus” Programming
+ Main Control Page
+ VFD Ready Status
+ VFD Running Status
+ VFD Alarm Status
+ VFD Frequency Setting
+ Motor Run Command
+ Motor Stop Command
+ Forward / Reverse Control
+ VFD Reset Command
+ Read Frequency Output
+ Read Current Output
+ Read Voltage Output
Video Tutorial
======
Related Software and Documents
Password Extract: plc247.com
If you have any questions or need any assistance in using the Weintek MT8071iE HMI to control Hitachi NES1 VFD with “Modbus RTU”, please comment below the article, plc247.com will answer you as soon as I read the comments.
Best Regards!
