Hello everyone, Mitsubishi Q-Seires PLC is one of the large and modern PLCs commonly used in factories, especially transmission lines with many Stepper/Servo motor axes.
Connecting HMI to PLC to control and monitor PLC is a necessity of any type of PLC, today plc247.com will guide you to connect HMI Delta DOP-107EV to Mitsubishi Q03UDV PLC via Ethernet port that both are integrated.
Mitsubishi Q-Series “Ethernet Port” Configuration
Below are the Ethernet port communication parameters that we need to install for the Mitsubishi Q03UDV (Other PLCs have similar settings)
Note: It is necessary to select “Enable online change” so that we can change the parameters of the PLC by entering parameters from the HMI
Delta HMI to “PLC Mitsubishi Q03UDV” Setting
We need to configure the following parameters for the HMI as shown below:
Project Video Tutorial
======
Related Softwares
+ Download GX-Works.2 Mitsubishi PLC Software
+ Download Delta HMI Programming Software
If in the process of using HMI Delta DOP-107EV to control and monitor PLC Mitsubishi Q03UDV you need any support, please comment below the article, plc247.com will reply to you as soon as I read the comments.
Best Regards!
