Hello everyone, in the previous post plc247.com guided you to use the Kinco HMI to control and monitor the Omron E5CC Temperature Controller, today I continue to guide you to control the Temperature Controller of Autonics
In this project plc247.com uses Model Autonics TK4S-T4SN and HMI Kinco MT4414TE (both au have built-in RS485 communication port)
HMI Kinco & Autonics TK4S “Connection Diagram”
+ Below is the RS485 communication protocol connection diagram between Kinco PLC and TK4S Controller
Autonics TK4S Modbus Parameters Setting
To be able to control Autonics TK4S with Modbus RTU, we need to set the following communication parameters:
Autonics TK4S Registers Address
+ Temperature Settings Address = 400001 (dec)
+ Temperature Monitoring Address = 301001 (dec)
HMI Kinco “Modbus RTU” Configuration
How have you set up the communication parameters for Autonics TK4S, the settings for HMI Kinco are the same:
HMI Programming
+ “Control Panel” Design
+ TK4S No.1 Set Temperature
+ TK4S No.2 Set Temperature
+ TK4S No.1 Read Temperature
+ TK4S No.2 Read Temperature
Video Tutorial
======
References
+ Download HMI Kinco Programming Software
+ Autonics TK4S Manual PDF Download
Password Extract: plc247.com
If you need assistance in using the Kinco HMI to control Autonics TK4S, please comment below the article, plc247.com will reply to you as soon as I read the comments.
Thanks and Best Regards!
